Galvanized sheet refers to the steel plate with a layer of zinc on its surface. Galvanizing is an economic and effective anticorrosion method of steel plate. Galvanized sheet can be divided into hot galvanized sheet and electro galvanized sheet according to production process. The zinc layer of hot-dip galvanized sheet is thick, which is used for normalized ABS E32 marine contruction steel parts with strong corrosion resistance. The thickness of zinc layer of galvanized sheet is thin and even, which is mostly used for painting or indoor products.
Based on the normalized ABS E32 marine contruction steel steel trade, the company mainly deals in Baosteel products: color coating, zinc plating, fingerprint resistance, cold rolling, hot rolling, pickling, electrical steel and other products, and can order the futures of the company's products on behalf of manufacturers. It has established cooperative relations with more than 2000 foreign customers. At the same time, it also operates a variety of products of related iron and steel enterprises. Annual sales of normalized ABS E32 marine contruction steel steel 3.6 million tons, standing stock of 400000 tons, has developed more than 10000 users. The company has a first-class marketing service system, strong storage and transportation capacity and supporting supply, cutting distribution capacity, and gradually build it into an important marketing channel.
Preheating cutting: The most effective way to prevent steel plate cutting cracks is to preheat before cutting. Before flame cutting, the steel plate is usually preheated, and the preheating temperature mainly depends on the quality level and thickness of the steel plate. The preheating method can be carried out with flame burner, electronic heating pad, or heating furnace. In order to determine the preheating effect of the steel plate, the required temperature should be tested at the heating point.
The microstructure of the quenched and tempered alloy steel, normalized ABS E32 marine contruction steel after conventional heat treatment is tempered sorbite. For parts with wear-resistant surface (such as gears and spindles), induction heating surface quenching and low-temperature tempering are carried out, and the surface structure is tempered martensite. The surface hardness can reach 55HRC-58HRC. After quenching and tempering, the yield strength of quenched and tempered alloy steel is about 800MPa, the impact toughness is 800kJ / m2, and the core hardness is 22HRC - 25HRC. If the cross-section size is large but not quenched, the properties will be significantly reduced.
The company formulates clear service process and service standard. To do a good job in after-sales service, first of all, clear service process and service standards should be formulated to let employees know which procedures to perform and which service standards to abide by.
Leave a Message