The company will also put Georgetown steelworks on "care and maintenance mode" and temporarily lay off or redeploy about 130 employees working at the steelworks and contractors while some normalized ABS E32 marine contruction steel maintenance employees will be on staff during the closure. It is stated that unemployment insurance and state-based unemployment support will be available immediately to workers affected by these changes.
In line with the service concept of "honesty first, customer first" and the service tenet of "all for customer satisfaction", the company adopts the acceptance and response mode of combining manual and automatic, and accepts the diversified service demands of customer business consultation, complaint declaration, business acceptance, etc. through telephone, fax, e-mail, visit, letter, etc.
Normalizing process of S355J2 steel plate: normalize the S355J2 steel plate in the bottom furnace, normalizing temperature is 880-910℃, holding time is 1.8-2.2min/mm, that is to get the required S355J2 + N steel plate. 355j2 + N steel plate is mainly used in large machinery manufacturing, equipment base, large welded steel structure, construction, bridge and other fields. With the continuous development of economy and the large-scale demand of equipment, the demand of ultra thick normalized ABS E32 marine contruction steel, S355J2 + N steel plate is increasing gradually.
SPA-C steel with the thickness range is 1.2-150mm, the width range is 1220-4200mm, and the length range is 5000-18000mm. Also note that the normalized ABS E32 marine contruction steel, SPA-C steel coil thickness should not exceed 25 mm. SPA-C steel’s mechanical properties is yield strength more than 325 MPa, tensile strength more than 450Mpa.
In 2016. Our company offer 1200 tons API 5L GR.B hot rolled coil to Bangladesh——100 tons for 3.9*625mm, and 1100 tons for 7*683mm. It is one tender project, we get the tender at the end of 2015, and arrange the production in 2016. They required the tolerance of thickness is +0.1/-0.2mm, and width tolerance is +/-0.5mm, which is a very high requirement for coil tolerance, but our mill handling this very well. and our Q/C department witness all of the process.
Our company has strict quality control standards. If you want to visit our factory, you are welcome at any time! We produce a lot of steel products every month to export normalized ABS E32 marine contruction steel to all over the world. Because our customers are from all countries, they will order a large number of steel products from our company every month.
Leave a Message