Smelting process of BV DH36 hull shipbuilding plate, container plate SPA-H weather-resistant steel: The molten iron for smelting SPA-H steel must be pretreated by molten iron desulfurization. Before entering the converter, the sulfur content of the molten iron is ≤0.010%, and the slag on the surface of the molten iron is cleaned. Nickel plates, copper particles or nickel-copper alloys are added to the converter with scrap steel. The carbon content of the converter smelting end is required to be less than 0.06% to prevent the molten steel from being oxidized.
Vigorously develop circular economy: the company adheres to the development path of circular economy, realizes the efficient utilization of energy and BV DH36 hull shipbuilding plate resources, implements "four closed circuits" for renewable gas, industrial water, solid waste and waste heat steam according to the reduction of resource consumption - reuse - recycling, vigorously promotes advanced technologies such as energy-saving new technologies, new processes, BV DH36 hull shipbuilding plate new materials, and promotes the competition of enterprises Struggle.
X-rays or γ-rays are projected on the surface of the steel plate, and rubber can be placed on the other side of the steel plate. Since the radiation propagates through the steel plate and is absorbed, the intensity is different due to the presence or absence of defects, so the film can record the shape and position of the defects. This BV DH36 hull shipbuilding plate method is sensitive to the detection of common steel plate defects such as slag inclusions, porosity and pores. The disadvantage is that it is difficult to find the specific depth of the defect and it is not easy to find cracks.
Low alloy high strength steel is a kind of engineering structural steel developed by adding a small amount of Mn, Si and a small amount of Nb, V, Ti, Al and other alloy elements on the basis of carbon structural steel, BV DH36 hull shipbuilding plate. The so-called low alloy means that the total amount of alloying elements in steel is less than 3%. High strength is relative to carbon engineering structural steel. The development principle of low alloy high strength steel is to use as few alloy elements as possible to obtain as high comprehensive mechanical properties as possible, so as to meet the requirements of use and low cost.
From the order to the delivery, there are three quality inspections to ensure that the qualified rate of finished products is more than 100%. We promise that every order will be tracked in a timely manner to ensure that customers can receive goods safely and constantly listen to their opinions and suggestions, reflect on our own problems, and let customers feel at ease. We have a large warehouse in Shanghai and Tianjin, which can provide customers with sufficient sources of supply.
Leave a Message