The quality inspection department is responsible for the inspection management of raw materials and finished products, and the quality inspection and acceptance of products and raw materials. Strictly abide by the company's management system, conscientiously exercise the management power given by the company, and put an end to all ultra vires; be responsible for the inspection of all kinds of raw materials entering the company, and put forward quality problems and handling opinions.
Wear resistant plate is composed of two parts, namely carbon steel plate and alloy wear-resistant layer. Under normal conditions, the thickness of the ABS F32 offshore steel sheets alloy wear-resistant layer of the wear-resistant plate is 1 / 3-1 / 2 of the total thickness. When working, the matrix provides the strength, toughness, plasticity and other comprehensive properties to resist external forces, and the alloy wear-resistant layer provides the ABS F32 offshore steel sheets wear-resistant property to meet the requirements of specific working conditions.
The advantage of hot-rolled stainless steel plate is that it can eliminate the damage caused by ABS F32 offshore steel sheets metal structure in the process of ingot casting to a certain extent, eliminate some tiny defects in the structure, refine the grains of stainless steel material, promote the structure of steel closer, and improve the performance of the material as a whole. This kind of lifting is mainly manifested in the rolling direction, which can make the ABS F32 offshore steel sheets steel no longer isotropic to some extent, and some defects such as bubbles, cracks and looseness formed during pouring can be eliminated under high temperature or high pressure.
In 2016. Our company offer 1200 tons API 5L GR.B hot rolled coil to Bangladesh——100 tons for 3.9*625mm, and 1100 tons for 7*683mm. It is one tender project, we get the tender at the end of 2015, and arrange the production in 2016. They required the tolerance of thickness is +0.1/-0.2mm, and width tolerance is +/-0.5mm, which is a very high requirement for coil tolerance, but our mill handling this very well. and our Q/C department witness all of the process.
Leave a Message